Because the Voyager 4230 will not power off, recover the headset itself first; Windows pairing and driver repairs are relevant only after its controls respond normally.
1. Recover the headset
- Connect the headset to its charger and leave it connected until fully charged. A low battery can prevent Bluetooth headphones from entering pairing mode or maintaining a connection.^1^
- While it remains connected to power, try its power control again.
- If it is still frozen, open the official Voyager 4200 series troubleshooting page and use Poly Lens to check for a firmware update or recovery option.^2^
- Consult the model’s setup/user guide or HP/Poly support if the headset remains permanently on.^3^
Do not apply a reset sequence intended for another Poly product. The available HP factory-reset page is not established as applicable to the Voyager 4230.
2. Re-pair it after the headset responds
Once the headset can power off and enter pairing mode:
- Open Start → Settings → Bluetooth & devices.
- Find the Poly/Voyager entry, select … → Remove device.
- Turn Windows Bluetooth off, wait 10 seconds, and turn it back on.
- Put the headset into pairing mode and keep it close to the laptop.
- Select Add device → Bluetooth, then choose the normal Poly/Voyager headset entry.
Microsoft recommends removing and adding the device again when it remains listed but will not connect.^1^
If the headset does not appear, go to Settings → Bluetooth & devices → Devices → Device settings and change Bluetooth devices discovery to Advanced, then search again.^4^
3. Repair the laptop Bluetooth side only if needed
If the headset is now responsive but still cannot connect:
- Run Settings → System → Troubleshoot → Other troubleshooters → Bluetooth → Run.
- Right-click Start → Device Manager → Bluetooth.
- Right-click the laptop’s Bluetooth adapter—not the headset—and select Update driver → Search automatically for drivers.
- If Windows finds nothing, install the Windows 11 Bluetooth/Wireless driver specifically provided for the OMEN Transcend 14 by HP, then restart. Microsoft notes that the PC manufacturer may provide the appropriate current driver.^4^
If the Bluetooth switch is missing or grayed out, fully power-cycle the laptop:
- Hold Shift while selecting Start → Power → Shut down.
- Wait one minute.
- Turn the laptop on and check Bluetooth again.
A shutdown—not Restart—completely powers off the PC’s Bluetooth hardware.^5^
If the headset remains unable to power off even after charging and firmware/recovery checks, that points away from an ordinary Windows pairing problem; use HP’s Poly support channel for model-specific hardware service.^6^
References
- [Windows 11](https://support.microsoft.com/windows/hardware/bluetooth/troubleshoot-bluetooth-not-connecting-in-windows)
- Voyager 4200 series - Troubleshooting | HP® Support
- Voyager 4200 series - Setup and User Guides | HP® Support
- [Windows 11](https://support.microsoft.com/windows/hardware/bluetooth/fix-bluetooth-problems-in-windows#general-bluetooth-troubleshooting-in-windows-11)
- [Windows 11](https://support.microsoft.com/windows/hardware/bluetooth/fix-bluetooth-disappeared-in-windows#summary)
- Poly Support | HP® Support