Run Brother’s Network Connection Repair Tool for the Ethernet-connected DCP-L2640DW; Brother recommends it specifically when this model cannot print a Windows test page, before reinstalling the driver.^1^
Since unplugging the printer already helped only temporarily, do not repeat that step.
1. Clear any blocked print job
- Open Start → Settings → Bluetooth & devices → Printers & scanners.
- Select Brother DCP-L2640DW → Open print queue.
- Cancel every listed document.
- Check the printer display for a paper jam, open cover, or other machine error.
A stuck job or printer-panel error can prevent subsequent jobs from printing over a wired network.^2^
2. Repair the Ethernet connection
- Confirm the Ethernet cable runs from the printer to your router or network switch—not directly to the PC unless your network was specifically configured that way.
- Look for an illuminated or blinking link light at the printer/router Ethernet socket.
- Open Brother’s model-specific test-page support article and download/run the Network Connection Repair Tool.
- Select the DCP-L2640DW when prompted and allow the tool to correct its network settings.
- When it finishes, try the test page again:
- Settings → Bluetooth & devices → Printers & scanners
- Select Brother DCP-L2640DW
- Select Printer properties → Print Test Page
The repair tool can correct the printer’s IP address and subnet mask when Windows is pointing to an obsolete network address.^3^
3. If error 1.0.20 remains
Remove and reinstall the printer with Brother’s current DCP-L2640DW driver:
- Go to Settings → Bluetooth & devices → Printers & scanners.
- Select Brother DCP-L2640DW → Remove.
- Download the latest Windows 11 driver or Full Driver & Software Package from Brother’s DCP-L2640DW support page.
- Run the installer and choose Wired Network/Ethernet when asked for the connection type.
- Complete installation, then print another test page.
Brother’s model-specific procedure lists driver reinstallation after network checks fail.^1^
If the Brother installer cannot find the printer, Windows also supports Settings → Bluetooth & devices → Printers & scanners → Add device → Add manually for network printers.^4^
The text “ERROR 1.0.20” alone does not establish whether the failure comes from Windows, Brother’s installer, or the printer. If these steps fail, note exactly where it appears—printer display, Windows test-page dialog, or Brother utility—and provide a screenshot.
References
- I cannot print a test page after installing the printer driver. (Windows) | Brother
- I cannot print using my Brother machine on a wired network (Windows/macOS) | Brother
- Use the Network Connection Repair Tool (Windows) | Brother
- [Windows 11](https://support.microsoft.com/windows/hardware/printer/fix-printer-connection-and-printing-problems-in-windows#general-troubleshooting)